fbpx

Arcoaire furnace error codes

Furnace0 comments

Arcoaire furnace error codes

In some cases, the furnace will automatically display an error code if the unit is too hot. The error codes usually range from “PH” (Too Hot) to “PC” (Possible Cooling Issue).

Arcoaire furnaces have been designed in such a way that they give off codes when they are experiencing issues. That way, you can figure out what’s wrong with your furnace and make sure it’s functioning properly. Knowing the error codes is important save you from a potentially costly repair bill.

To know any faulty parts of your Arcoaire furnace, you need to identify which ones are bad and which still should be functioning properly. Once you identify faulty parts, you must replace them as soon as possible so that your Arcoaire doesn’t fail you again due to a potential overheating issue.

Arcoaire furnace error codes may vary from appliance to appliance. One way to get the code is to look for the model number on a sticker or an identification tag.

Arcoaire furnace error codes are categorized into three types:

1. Arcoaire burner error

2. Arcoaire thermostat error

3. Arcoaire blower assembly/fan motor failure

Arcoaire furnace error codes indicate the current state of your central heating system.

Let’s say you just installed your Arcoaire furnace, and it’s working fine, but you noticed that the furnace gives an error code on occasion. What does this mean? Your controller board inside the central heating system generates the error code. These codes are sent to you if something goes wrong with your heater.

If this happens, don’t panic. Instead, read more about these error codes and use them as a guide to help figure out what’s going on with your heater.

“Inspections, Installations, Repairs & Maintenance”